GE MN-ValVue-v2-8-IOM Manual de servicio Pagina 96

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 660
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 95
ValVue Digital Communications Software Ver. 2.80
96
GE Oil & Gas
$$Switch1Value Value at which Switch 1 activates
$$Switch1Action Switch is Normally Closed or Normally Open
$$RawSignal Signal Value in A/D Counts
$$RawPosition Position Value in A/D Counts
$$PositionStopLow Position A/D Counts at the Lower Stop
$$PositionStopHigh Position A/D Counts at the Upper Stop
$$OptionConfig
$$OptionConfigEx0
$$OptionConfigEx1
$$OptionConfigEx2
$$OptionConfigEx3
Data describing the hardware installed on the positioner
$$Friction Friction Measured from a Standard Actuator Signature
$$FLowerSpringRange Lower Spring Range measured from a standard actuator signature
$$FupperSpringRange Upper Spring Range measured from a standard actuator signature
$$LowPressureActual Pressure when the actuator is exhausted
$$HighPressureActual Supply Pressure
$$Speed Speed at which the last diagnostic test was run
$$SpeedSaved Speed at which the saved standard signature was run
$$SpeedBaseline Speed at which the baseline standard signature was run
$$LowerSpringRange
$$LowerSpringRangeSaved
$$LowerSpringRangeBaseline
Lower Spring Range calculated from the current, saved, or baseline stan-
dard signature
$$UpperSpringRange
$$UpperSpringRangeSaved
$$UpperSpringRangeBaseline
Upper Spring Range calculated from the current, saved, or baseline stan-
dard signature
$$Signature Position/Pressure Pairs -gathered during the Standard Signature Test
$$SignatureSaved Position/Pressure Pairs - saved in the Saved Standard Signature
$$SignatureBaseline Position/Pressure Pairs- saved in the Baseline Standard Signature
Table 5 Report Setup Parameters (Continued)
Report Parameter Information Provided in Report
Vista de pagina 95
1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 659 660

Comentarios a estos manuales

Sin comentarios