
35-201578-178 (Rev 09/16/13)
English
MAINTENANCE / CLEANING
6
• Tomaintainthehighestopticaleciency,occasional
cleaning of the outer lens surface may be needed,
with frequency dependent on local conditions.
• Use a mild soap or detergent, which is essentially
neutral pH (pH approximately 6 to 8), nonabrasive,
and which contains no chlorinated or aromatic
hydrocarbons.
• Wash thoroughly, using a soft cloth.
• Rinse with clean, cold water and wipe dry.
OCCUPANCY SENSOR (optional)
5
• The programmable occupancy sensor is shipped with
adefaultprogramwhichmaybemodiedusingthe
WattStopper®FSIR-100wirelessIRcongurationtool
(sold separately).
• The FSIR-100 includes a complete set of instructions
tocreateandsavealternativeprogramcongurations
toquicklyapplytomultiplextures.
These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in
connection with installation, operation or maintenance. Should further information be desired or should particular problems arise which are not
coveredsucientlyforthepurchaser’spurposes,themattershouldbereferredtoGELighting.
g
GELighting•1-888-MY-GE-LED(1 - 888 - 69 - 43 - 533)•www.gelighting.com
GE Lighting is a subsidiary of the General Electric Company. Evolve and the GE brand and logo are trademarks of the General Electric Company.
© 2013 GE Lighting. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
Comentarios a estos manuales