GE Medium Square Guía de instalación descargar pdf (Pagina 3)

WIRING

• NOTE: Make all electrical connections in accordance

with the National Electrical Code and any applicable

local code requirements.

• NOTE: Verify that supply voltage is correct by

comparing it to nameplate.

• External dimming control cable, when applicable, is

supplied with barrel splice connectors to receive

22 to 16 AWG dimming control wires.

• Feedsupplywirethroughconduitandintodisconnect

housing.

• Makenecessarywireconnections.

• Slidetheextrusionattachedtotheluminaire 

completely onto the hanger extrusion.

• Replacecoverplate.

- (Cover plate is necessary to lock luminaire

into place on the hardware, cover electrical

connections, and if so equipped, seal from water.)

WARNING

Risk of injury. LED light source achieves full intensity

immediately upon being powered on. Do not look directly

at LED light source while energized.

FIGURE 2 FIGURE 3 FIGURE 4

B. Luminaires with Primary Disconnect

Outlet Box Hanging Hardware Figure 2,

Outlet Box Hanging Hardware Figure 3,

and Rigid Pendant Hardware Figure 4

• Removecoverplate(s)andattachhanginghardware

to pendant conduit and tighten screw, or attach to

the junction box.

• NOTE: Verify that dimming voltage is correct by

comparing it to the product nameplate and make

sure the electrical connection and separation of

dimming and branch circuit conductors comply with

national electrical code and applicable local electrical

codes.

1 2 3 4 5 6 7 8 ... 15 16

Sin comentarios

GE Medium Square Guía de instalación Pagina 3