GE BR Series Guía de instalación

Busca en linea o descarga Guía de instalación para No GE BR Series. GE BR Series Installation Guide Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 4
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
GE
Lighting
Installation Guide
imagination at work
For Backlit Recessed Troffer Luminaires
Driver Replacement
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING/AVERTISSEMENT
RISK OF ELECTRIC SHOCK
• Turn power off before inspection, installation or removal.
• Properly ground electrical enclosure.
RISK OF FIRE
• Follow all NEC and local codes.
• Use only UL approved wire for input/output connections.
Minimum size 18 AWG (0.75mm
2
).
RISQUES DE DÉCHARGES ÉLECTRIQUES
• Coupez l’alimentation avant d’’inspecter, installer ou déplacer le luminaire.
Assurez-vous de correctement mettre à la terre le boîtier d’alimentation électrique.
RISQUES D’INCENDIE
• Respectez tous les codes NEC et codes locaux.
• N’utilisez que des ls approuvés par UL pour les entrées/sorties de
connexion. Taille minimum 18 AWG (0.75mm
2
).
Prepare Electrical Wiring
Electrical Requirements
• The LED driver must be supplied with 120-277 VAC or
347VAC, 50/60 Hz and connected to an individual properly
grounded branch circuit, protected by a 20 ampere circuit
breaker. Use min. 75°C supply conductor.
Grounding Instructions
The grounding and bonding of the overall system shall
be done in accordance with National Electric Code (NEC)
Article 600 and local codes.
Components Supplied
• Driver of luminaire
Tools and Components Required
• T15 torx screwdriver
• UL listed conduit connections per NEC/CEC for nominal
conduit trades sizes ½” or ¾”
• UL recognized wire connectors
Save These Instructions
Use only in the manner intended by the manufacturer.
If you have any questions, contact the manufacturer.
Specications
Description Code Corresponding Luminaires
Backlit Troffer 22 and 14 driver (1-10V dimming) Backlit Troffer 22 and 14 Series
Backlit Troffer 24 driver (1-10V dimming) Backlit Troffer 24 Series
Vista de pagina 0
1 2 3 4

Indice de contenidos

Pagina 1 - Driver Replacement

GELightingInstallation Guideimagination at workFor Backlit Recessed Troffer LuminairesDriver ReplacementBEFORE YOU BEGINRead these instructions comple

Pagina 2 - Wiring Diagrams

Wiring DiagramsPSU(1-10V) +(1-10V) –+–Light Engine+–LineNeutralRemote Switch 1-10V (Optional)VIOLETGREYREDBLUEBLACKWHITE(1-10V) –(1-10V) +GNDNL1-10V D

Pagina 3 - Driver Replacement Steps

1 2Rotate latches to unlock the front bezel. Swing down panel and lift off front bezel.Driver Replacement StepsFor Backlit Troffer 22 and 24: unfasten

Pagina 4 - IND125-081414

87Rotate latches to lock the front bezel.Hang panel on its hinges and swing up into place. This device complies with Part 15 of the FCC Rules. Operati

Comentarios a estos manuales

Sin comentarios