GE GFK-2489 Manual de usuario descargar pdf (Pagina 74)

GFK-2489 Chapter 3 AP Management 3-41

▪

Num EPs—Number of endpoints connected to this Remote.

Endpoint Database Menu

The Endpoint Database Menu shows all non-TS Wireless Ethernet devices that are known to

the transceiver; this is equivalent to the AP table of IP devices. The list shows endpoint MAC

and IP addresses, as well as packet exchange data.

A Remote does not have an IP address; rather, it acts as a transparent bridge for IP traffic to

the connected Ethernet endpoint.

EndPoint Database Menu

Number of connected endpoints: 1

EP # MAC Address AgeOut Via Remote IP Address IX Pkts RX Pkts

1 00:50:c5:00:92:99 9 7664 169.254.0.100 442 439

Select a letter to configure an item, <ESC> for prev menu

(Lists all equipment attached to Remote transceivers in the network)

▪ MAC Address—Ethernet address of the endpoint device.

▪ AgeOut—Number of minutes until the device (address) is removed from the table.

Each transceiver maintains a table with the addresses of the devices it communicates

with. The age time countdown is restarted to its default setting every time a message to or

from that device is detected. If no traffic with that device happens, it then “ages out” of the

table. When traffic is detected, it is included again in the table.

▪ Via Remote—Unit ID of the transceiver connected to this device.

▪ IP Address—IP Address of endpoint device (not the Remote radio itself).

▪ TxPkt—Number of packets received from the endpoint device and passed over the air.

▪ RxPkts—Over-the-air data packets received by the transceiver and passed on to the

endpoint device.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 183 184

Sin comentarios

GE GFK-2489 Manual de usuario Pagina 74