GE GFK-2489 Manual de usuario descargar pdf (Pagina 20)

1-14 TranSphere TS Wireless Extended Range IP Networking Transceivers – January 2008 GFK-2489

Quick Start Instructions

Listed below are the basic steps for installing TranSphere TS Wireless transceivers. Refer to

the appropriate sections in the manual for detailed information.

1. Initial Checkout

▪ Set the equipment up in a tabletop arrangement as described in Chapter 2: Tabletop

Setup and Evaluation.

▪ Follow all steps to ensure proper cable connections and unit configuration. As a

minimum, Access Points must have the following programmed: IP Address, IP

Network identifier, and Radio Network Address. (RF output power and Password

should also be reviewed and set if necessary.) Remote radios normally require only a

Radio Network Address to be set. (Note: The Remote Radio Network Address must

match that of the AP.)

▪ Connect data equipment to the transceivers. Use LAN/ETH ports for Ethernet

systems, or COM2 ports for Serial data systems.

▪ Verify proper exchange of data communications by viewing the LEDs. The following

indications should be seen on the LED panel within 30 seconds of startup:

PWR—Lit continuously

LINK—Lit continuously

ETH—Lit continuously (unless Sleep is activated)

COM2—Blinking to indicate exchange of data communications

2. Endpoint Connectivity (PING) Test—for Ethernet Systems Only

▪ For Ethernet systems, verify the link integrity between the Access Point and endpoint

devices connected to Remotes by issuing a PING command from the AP. Below is a

basic setup diagram for the PING test. (Note: Endpoint devices must have a

compatible IP address for this test to work.)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 183 184

Sin comentarios

GE GFK-2489 Manual de usuario Pagina 20