GE VBC Guía de instalación descargar pdf





This luminaire is designed for pendant or ceiling mounting applications and should be

installed and maintained according to the following recommendations.



This luminaire has been properly packed so that no parts should have been damaged

during transit. Inspect to conrm.

The carton should contain a luminaire complete with mounting assembly and the lamp

installed in the socket (medium base version only).



 

1. Loosen three refractor ring screws and remove refractor and refractor ring from

luminaire housing.

2. Loosen reector screws, rotate and remove reector. Remove nomex wire shield.

Note: Nomex shield may be discarded if 105°C, or above, wiring is used.

3. Thread pendant/conduit into top housing (Figure 4) or mounting hub (Figure 6),

and tighten lock nut.

4. Feed wires through pendant and extend approximately 6 inches of wire into

housing and make necessary connections. (See Wiring section) Connect supply

ground lead to the luminaire green lead.





 Follow installation instructions





 Turn power o before servicing

 see instructions

 

Mounting

Plate

Junction

Box

Locking

Screw

Wire

Clip















If unit is multi-volt, see Wiring Section below.



 

1. Attach mounting plate to electrical junction box and pull incoming power leads

through oval hole in mounting plate.

2. Suspend luminaire below j-box and attach wireform by squeezing legs together

slightly and inserting through rectangular j-box mounting plate holes.

3. With luminaire hanging below j-box make electrical connections and place wires

into j-box. (Figure 1)

4. Swing luminaire into place, mate two mounting plates and slide together until

plates lock into place. (Figure 2)

5. To remove xture from j-box, luminaire must be opened, by loosening three refractor

ring screws, then loosening reector screws, rotating and removing reector. The

locking screw must be backed out approximately one-half inch. (Figure 3)



Locknut

(By User)

Cover

6 Inches

(152mm)



Cover

Connectors

Wire Clip

Ground Lead

Ballast

Mounting

Plates

Wireform

Lighting Solutions

These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation, operation or

maintenance. Should further information be desired or should particular problems arise which are not covered suciently for the purchaser’s purposes, the matter should be referred to

GE Lighting Solutions.