GE UVB36DKBB Manual y guía del usuario Pagina 16

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 40
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 15
16
49-80777
Installation Instructions
1
INSTALL DOWNDRAFT VENT
A
Two stabilizing brackets must be installed on
each side of the downdraft vent.
For right-side or straight-down blower
discharge, fasten the stabilizing brackets at
locations A, B, D and E.
For left-side blower discharge, fasten the
stabilizing brackets at locations B, C, D and E.
B
Place the downdraft vent into the countertop
cutout so that the back flange of the vent is
sitting on top of the countertop.
C
Secure the screws for the stabilizing brackets
to the cabinet back and side walls.
D
Confirm the vent system is plumb and square
with the cabinetry.
E
Place Cooktop into the countertop cutout.
There should be a 1/8” minimum gap
between the front of the vent trim and the rear
of the cooktop.
F
Connect duct. Use a roof or wall cap (with
damper) that is intended for use with kitchen
hoods and vent systems.
INSTALLATION INSTRUCTIONS
A
C
A
D
C
B
E
4 to 5”
4 to 5”
Top
Brackets
Bottom
Brackets
Bracket
Cabinet Back
Wall
Downdraft Vent
Location A
TOP VIEW
Level
Level
Vista de pagina 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Comentarios a estos manuales

Sin comentarios