GE EASM & EAMM Guía de instalación descargar pdf (Pagina 3)

Nut Plate

Adapter Block

3/8-16 Washer and Bolts

Torque Bolts to 25 - 32ft-lbs.

(34-43 N-m)

ADAPTER PLATE FOR

SQUARE POLE

FIGURE 6

DRILLING TEMPLATE

SQUARE POLE MOUNTING

.312 in. DIA.

(8 mm DIA.)

5.250 in.

(133 mm)

(MIN.)

1.812 in.

(46 mm)

1.250 in. DIA.

(32 mm DIA.)

(HOLE)

.656 in. (17 mm)

1.312 in. (33 mm)

2.196 in.

(56 mm)

4.392 in.

(112 mm)

.438 in. DIA.

(11 mm DIA.)

(2 PLACES)

FIGURE 5

FIXTURE ARM TO ARM ADAPTER

Torque Top Bolt

to 25 - 32 ft-lbs.

(34-43 N-m)

Torque Bottom Bolt

to 25 - 32 ft-lbs.

(34-43 N-m)

FIGURE 7

• NOTE: Make all electrical connections in accordance

with the National Electrical Code and any applicable

local code requirements.

• Strain relief for incoming power must be provided in

the pole top by the customer.

• Supply Wire Type and Size, for Customer Connection

to Terminal Board: 16 AWG (1.5mm

) to 6 AWG

(10mm

) Solid or Stranded.

WIRING

CAUTION

Risk of Damage or Injury: Door should be closed with

screw until xture in nal location.

Terminal Board Connections:

Terminal Board Position Supply Type

L1 High Line

G Ground

N/L2 Low Line/Neutral

• NOTE: Verify that supply voltage is correct by

comparing it to nameplate inside door or on carton.

3c Square Pole Architectural Arm Mounting

This luminaire has been congured the same as 3b

and an adapter plate has been included to mount to

a square pole. Hole pattern on square pole shall be in

accordance with Figure 5.

• Orient adapter block so that the end marked top is in

the up position.

• With adapter block end oriented properly, mount

adapter block to pole with the nut plate and 3/8-16

bolts and washer supplied as shown. Torque 3/8-16

bolts to 25 - 32ft-lbs (34-43 N-m). (See Figure 6)

• Place xture against adapter block.

• In top location install 3/8-16 bolt through lock

washer, washer and mounting arm as shown.

(See Figure 7)

• Open arm door and Install 3/8 bolt into tapped hole

of adapter block. (See Figure 7)

• Torque top and bottom bolts to 25 - 32 ft-lbs (34-43 N-m).

• Inspect installation to ensure xture is secure.

Dimming Input/Output

Control Voltage

Low (0V) High(7.5-10V)

Nominal Input Wattage

20% of Max 100%

Nominal Lumen Output

External Dimming Control (If Applicable):

• Gray Lead = 0VDC (-)

• Violet Lead = Up To 10VDC (+)

•

Linear Transition between Low and High

•

Component and system tolerance may aect the

end point levels and linearity of transition

1 2 3 4 5 6 7 8 ... 11 12

Comentarios a estos manuales

Sin comentarios

GE EASM & EAMM Guía de instalación Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para No GE EASM & EAMM