GE JXHC1 Manual de instalación Pagina 2

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 2
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 1
2
Installation Instructions
49-80087-7 07-13 GE
Printed in China
REMOVE KNOCKOUT
Insert the blade of a flat blade screwdriver into the
preferred knockout slot and bend until the knockout
is removed.
2
THREAD WIRES THROUGH THE
KNOCKOUT
Thread the cord wires through the knockout hole.
3
PULL CORD THROUGH THE
KNOCKOUT
From inside of the hood junction box, thread wires
through the strain relief nut and tighten down nut until
secure.
4
CONNECT THE CORD WIRES
Inspect the junction box wires to determine the type of
connections that should be made.
For hoods with a ground screw:
A
Connect the green ground wire to the green ground
screw.
B
Using the wire nuts provided, connect the black
power cord lead to the stripped black lead and the
white power cord lead to the stripped white lead in
the connection box.
C
All electrical connections should be inspected
carefully before replacing the connection box cover.
For hoods with a ground wire:
A
Using the (2) wire nuts provided, connect the black
power cord lead to the black junction box lead.
Connect the white power cord lead to the white
junction box lead.
B
Locate the power cord green ground wire, and cut off
the ring terminal and strip 1/2" of insulation.
C
Using the third wire nut, connect the power cord
ground wire to the green junction box lead.
D
All electrical connections should be inspected
carefully before replacing the junction box cover.
5
REPLACE CONNECTION
BOX COVER
Replace the connection box cover using the screws
removed in Step 1.
6
INSTALL HOOD
Return to and proceed with the Installation Instructions
to install the range hood.
7
REMOVE CONNECTION BOX COVER
Locate the hood connection box and remove its cover.
1
Vista de pagina 1
1 2

Comentarios a estos manuales

Sin comentarios